• Table of contents
• Ericsson RBS 2000
  • Requirements
  • Setup
  • Status

Ericsson RBS 2000¶

There is some initial/experimental code in OpenBSC to support the Ericsson RBS 2000 family of BTS.

As opposed to Siemens/ip.access, Ericsson A-bis is much farther away from the specs, particularly
since their Organization and Maintenance Layer (OML) is a proprietary protocol called OM2000.

Nonetheless, we have been making quite a bit of progress in getting the RBS 2000 series supported.
Right now it is still not complete. Don't expect anything to work at this stage.

We are collecting links to documents describing the Ericsson RBS architecture at RBS_Links

Requirements¶

• Ericsson RBS 2000 series BTS
• E1 or T1 interface card, supported by the DAHDI driver. WE DO NOT SUPPORT RBS with mISDN drivers!
• RBS with software + IDB in default configuration, especially OML TEI set to 62
• /etc/dahdi/system.conf with "dslot=1,4" in it

Setup¶

• Check that dahdi_tool is showing the link as OK, otherwise you have some wiring/polarity issues
• Create an openbsc.cfg that lists your BTS as 'rbs2000' type (see attached example)
  • do not try to be clever and use non-standard E1 timeslot assignments, the code is hard-coded and assumes certain values
• start osmo-nitb as usual

Status¶

So far, you should get

• A-bis link initialization, i.e. BSC telling the BTS to use TS1 as signalling for IXU/DXU OML
• OpenBSC configuring and starting the CF (central function)
• You can manually connect, configure and enable the IS via the VTY
• With some luck, the OML SAPI to the RRU/TRU's can then be established
• Using the '-p foo.pcap' option, you can write a PCAP protocol trace to be used with wireshark and our OM2000 wireshark dissector

What is NOT supported yet:

• Actually initializing the transceivers and Um timeslots
• Any actual communication with phones
• Any form of GPRS. This requires us to implement a PCU compatible with the Ericsson PCU-CCU A-bis protocol.