Auerswald COMmander Basic2 Electronics » History » Version 3
laforge, 02/20/2022 02:19 PM
1 | 1 | laforge | h1. Auerswald COMmander Basic2 Electronics |
---|---|---|---|
2 | |||
3 | h2. Mainboard |
||
4 | |||
5 | {{thumbnail(Auerswald_COMB2_mainboard1.jpg)}} |
||
6 | {{thumbnail(Auerswald_COMB2_mainboard2.jpg)}} |
||
7 | {{thumbnail(Auerswald_COMB2_mainboard_detail.jpg)}} |
||
8 | |||
9 | h2. 8 S0 Module |
||
10 | |||
11 | 3 | laforge | As can be seen clearly on the picutre, it uses the [[CologneChip_HFC|CologneChip HFC-8S]] 8-port S/T interface IC. There's a lattice glue logic chip for interfacing with the backplane bus, and the analog frontend + magnetics sections for 8 ports. Four ports have jumper blocks to change the NT/TE cross-over, while the other 4 ports are static. |
12 | |||
13 | 2 | laforge | {{thumbnail(Auerswald_COMmander_8S0_top.jpg)}} |
14 | {{thumbnail(Auerswald_COMmander_8S0_bottom.jpg)}} |
||
15 | |||
16 | 1 | laforge | h2. 4 S0 Module |
17 | |||
18 | 2 | laforge | This isba basically just a partially populated 8S0 module, using a HFC-4S chip instead of the HFC-8S. |
19 | |||
20 | {{thumbnail(Auerswald_COMmander_4S0.jpg)}} |
||
21 | {{thumbnail(Auerswald_COMmander_4S0_top.jpg)}} |
||
22 | {{thumbnail(Auerswald_COMmander_4S0_bottom.jpg)}} |
||
23 | |||
24 | 1 | laforge | h2. 8 a/b Module |
25 | |||
26 | 2 | laforge | {{thumbnail(Auerswald_COMmander_8ab_top.jpg)}} |
27 | {{thumbnail(Auerswald_COMmander_9ab_bottom.jpg)}} |
||
28 | {{thumbnail(Auerswald_COMmander_8ab.jpg)}} |
||
29 | |||
30 | 1 | laforge | h2. S2M Module |
31 | 2 | laforge | |
32 | {{thumbnail(Auerswald_COMmander_S2M_top.jpg)}} |
||
33 | {{thumbnail(Auerswald_COMmander_S2m_bottom.jpg)}} |