Project

General

Profile

Actions

Support #4064

closed

bom / parts order / production of 3 clock-gen v2 prototypes

Added by laforge almost 5 years ago. Updated about 2 years ago.

Status:
Resolved
Priority:
Normal
Assignee:
Target version:
Start date:
06/19/2019
Due date:
% Done:

100%

Spec Reference:

Description

mschramm, please complete the BOM (as needed) and order parts for three clock-gen boards. I expect to place the PCB order today.

After board and parts arrive, roh can assemble them.

Actions #1

Updated by mschramm almost 5 years ago

  • Status changed from New to In Progress
Actions #2

Updated by mschramm almost 5 years ago

  • % Done changed from 0 to 10

parts ordered

Actions #3

Updated by mschramm almost 5 years ago

  • Target version set to hw-v2
  • % Done changed from 10 to 20

parts have arrived, waiting for the v2 PCBs.

Actions #4

Updated by roh over 4 years ago

boards have arrived and one prototype was completed on 2019-07-05

is there already software for this to flash and test the board?

Actions #5

Updated by laforge over 4 years ago

it's a pity that only one board was assembled, and that I only realize this after roh is on holidays. Assemble them meant all three :/

mschramm, please pack populated and unpopulated boards as well as parts before ccccamp, so I can give them to horiz0n and/or other interested parties.

Actions #6

Updated by laforge over 4 years ago

As horiz0n didn't have time to work on this (which is perfectly fine) I wanted to figure out who has which prototype and/or parts. mschramm can you help clarify if any parts/boards/... are still at the office? In the worst case I'd probably simply re-order a couple of boards.

Actions #7

Updated by mschramm about 4 years ago

  • % Done changed from 20 to 30

We still have two unpopulated v2 PCBs and enough parts for these two PCBAs.

Actions #8

Updated by roh about 4 years ago

all complex semiconductors, inductors and resistors placed.

Actions #9

Updated by roh about 4 years ago

we have 2 more completed pcb now. i debugged the soldering it till i got a swd connect on both boards to the mcu. clock chip still needs validation.

Actions #10

Updated by laforge almost 4 years ago

  • Status changed from In Progress to Resolved
  • % Done changed from 30 to 100
Actions #11

Updated by laforge about 2 years ago

does anyone recall where those prototype boards went? Kyle Tuft has shown up on twitter (https://twitter.com/tuftkyle/status/1506730186556936195?s=20&t=1v497Jmcly_X1lY39kB9JQ) and is interested in moving the project ahead (i.e. SAMD21 firmware).

Actions #12

Updated by mschramm about 2 years ago

IIRC, ahuemer and Hoernchen have a version 2 PCBA at hand.

Actions

Also available in: Atom PDF

Add picture from clipboard (Maximum size: 48.8 MB)