Osmo-nvs-gps » History » Version 4
laforge, 02/19/2016 10:48 PM
1 | 3 | laforge | [[PageOutline]] |
---|---|---|---|
2 | 1 | laforge | = osmo-nvs-gps = |
3 | |||
4 | This is a small evaluation board for the NVS NV08C-CSM integrated GPS, Galileo and Glonass receiver. |
||
5 | |||
6 | It provides access to the two UARTS as well as SPI and I2C interface of the module, optional backup |
||
7 | battery for avoiding cold-start on power-loss and a MCX socket for connecting the antenna. |
||
8 | 2 | laforge | |
9 | |||
10 | [[Image(osmo-nvs-gps.jpg, 50%)]] |
||
11 | 3 | laforge | |
12 | == Schematics and component placement == |
||
13 | |||
14 | The schematics and component placement files can be found attached to this page. |
||
15 | |||
16 | |||
17 | == Part numbers == |
||
18 | |||
19 | All capacitors, inductors and resistors are 0603 footprint, with the exception of C1 (0402). |
||
20 | |||
21 | * MCX socket is a Tyco Electronics 1-1337581-0 |
||
22 | * CR2032 battery holder is a MPD BA-2032 |
||
23 | 4 | laforge | * The 2.5mm jacks are SJ-2523-SMT |
24 | 3 | laforge | |
25 | == Jumpers == |
||
26 | |||
27 | * J1 connects VBAT with VCC, i.e. should ''only'' be placed if you ''do not have a battery attached'' |
||
28 | * J1 connects VIO with VCC. This is the case when VIO (Voltage for digital i/o) is ''not provided by an external circuit attached to X2 |
||
29 | * JP4 is the power supply connector. Apply 3.8..6V regulated DC power to it. Center pin is positive, outer pins both GND |