Revision bea9406b
Added by Kévin Redon over 4 years ago
- added
- modified
- copied
- renamed
- deleted
WARNING: this project only applies to the first generation SIMtrace hardware, which uses the Atmel AT91SAM7S micro-controller. This project is not supported anymore. The hardware and software are still working, but won't get updates. This project is now replaced by SIMtrace2, which uses the SAM3S replacement micro-controller.
schematic: mark USB reset circuit as dot no place
the additional circuit to reset USB (by pulling D+ low) is not
required anymore since the USB controller in the SAM3S integrates
this capability.
the SAM3S-EK Development Board also demonstrates only the inline
27 Ohm termination resistors are required.
this change has been tested (behind 2 USB HUBs).
the RESET button still works.
resetting using DFU into the bootloader and starting the
application from the bootloader still works.
Change-Id: I648a041f6d3cf456f1783249546078961f85e662