Sfp-experimenter » History » Version 3
laforge, 10/07/2018 06:55 AM
1 | 1 | laforge | h1. sfp-experimenter |
---|---|---|---|
2 | |||
3 | This is the twin brother of the [[sfp-breakout]] board. It contains LVDS receiver/transmitter circuits, so you can use single-ended signals on the electrical side. |
||
4 | |||
5 | h2. Schematics / Design files |
||
6 | |||
7 | The schematics / design files are kept in git at https://git.osmocom.org/osmo-small-hardware/tree/sfp-breakout |
||
8 | |||
9 | 3 | laforge | You can see the design discussion in #3314 and notes from board-bringup at #3523 |
10 | 2 | laforge | |
11 | 1 | laforge | h2. Photos |
12 | |||
13 | !sfp-experimenter.jpg! |
||
14 | |||
15 | h2. Availability |
||
16 | |||
17 | h2. Errata |
||
18 | |||
19 | h3. sfp-experimenter v1 |
||
20 | |||
21 | h4. R6 pull-down re-work |
||
22 | |||
23 | there was a need to place a bias resistor from RD_N to ground (pin4 on ic2) or the whole board would not work. ic2 has internal 100ohm prom pin3 to pin4 and pullups of ~300k to vcc. 100k pulldown on one leg pushes it into the proper operating range. due to the 100ohm its not neccessary to have more than one pulldown. |
||
24 | |||
25 | !sfp-experimenter-r6-rework.jpg! |