pfassberg
- Login: pfassberg
- Copyright License:
- Registered on: 03/20/2024
- Last connection: 03/23/2024
Issues
open | closed | Total | |
---|---|---|---|
Assigned issues | 1 | 0 | 1 |
Reported issues | 3 | 2 | 5 |
Projects
Project | Roles | Registered on |
---|---|---|
E1/T1 Hardware Interface (including icE1usb) | Contributor | 03/27/2024 |
osmo-e1d | Contributor | 03/27/2024 |
Retronetworking | Contributor | 03/27/2024 |
BBS-Revival | Contributor | 03/27/2024 |
FidoNet | Contributor | 03/27/2024 |
linmodem | Contributor | 03/27/2024 |
UUCP and UseNet | Contributor | 03/27/2024 |
Z-Netz | Contributor | 03/27/2024 |
OCTOI - Osmocom Community TDM over IP | Contributor | 03/27/2024 |
osmo-isdntap | Contributor | 03/27/2024 |
Retro-GSM | Contributor | 06/12/2024 |
Retrocomputing | Contributor | 03/27/2024 |
Activity
04/04/2024
- 06:50 PM E1/T1 Hardware Interface (including icE1usb) Support #6434 (New): D-channel do not recover after underrun
- The two units I use are in locations where there is no GNSS coverage.
After some hours of operation there is 7500 ...
03/27/2024
- 10:02 PM E1/T1 Hardware Interface (including icE1usb) Wiki edit: Isochronous_USB_Issues (#20)
- Added Waveshare CM4 and RPi 5
- 01:42 PM E1/T1 Hardware Interface (including icE1usb) Support #6412: No alignment
- laforge wrote in #note-3:
> On Thu, Mar 21, 2024 at 02:04:37PM +0000, pfassberg wrote:
> > Unfortunately I get this...
03/22/2024
- 06:01 PM E1/T1 Hardware Interface (including icE1usb) Feature #6417 (Resolved): CRC4 configuration
- Even if the icE1usb support CRC4 enabled or disabled the osmo-e1d process need CRC4 on Rx to align.
I suggest that... - 05:52 PM E1/T1 Hardware Interface (including icE1usb) Support #6416 (Feedback): Serial debug tty port speed
- I'm trying to read the debug info from the firmware in icE1usb via the 2.5 mm serial connector. I'm using the sysmoc...
- 05:44 PM osmo-e1d Bug #6415 (New): osmo_panic after truncated packet
- I'm running icE1usb connected to a Raspberry CM3 module.
A few times a day osmo-e1d crashes with the following out...
03/21/2024
- 02:04 PM E1/T1 Hardware Interface (including icE1usb) Support #6412: No alignment
- laforge wrote in #note-1:
> It most likely is the lack of CRC4. As far as I recall from memory, the gsteware support...
03/20/2024
- 09:47 PM E1/T1 Hardware Interface (including icE1usb) Support #6412 (Resolved): No alignment
- I'm testing icE1usb to connect a ISDN PBX to a switch partly over SDH....
Also available in: Atom