Philips TA Mini Pad Euro¶

A ISDN TA made by Philips.

Variants

Hardware¶

AT-Commands¶

# authorize (default-pw: 1234)
AT%L1234

<pre>
AT%L1234
R/W access
OK
ATI
AT.. - prefix                        A/   - repeat last command
ATA  - connect incoming call         ATD  - dial command
ATE  - echo mode                     ATH  - disconnect
ATI  - information                   ATO  - connect
ATQ  - surpress feedback             ATS  - read/write S register
ATV  - feedback verbal/numeric       ATX  - extended output format
ATZ  - load stored profile           AT&C - DCD mode
AT&D - DTR mode                      AT&F - load factory setting
AT&P - select protocol               AT&R - CTS/RTS mode
AT&S - DSR mode                      AT&T - tests/loops
AT&V - list profile                  AT&W - store profile
AT&Z - store/list number             AT$B - set HDLC mode block size
AT$D - direct call                   AT$F - set HDLC mode flow ctrl.
AT$I - data guard                    AT$L - activate SW download
AT$S - set rate adapt. prot.         AT$X - extended ISDN info output
AT%C - charging information          AT%H - ISDN history buffer
AT%I - ISDN connection status        AT%M - select menu
AT%P - portlines status              AT%S - ISDN statistics
AT%Y - X.25 history buffer           AT#D - set/read date
AT#T - set/read time·················
OK

ATI1
PHILIPS  TA mini·
Product Code 245 538
Software Version 2.10 DSS1
Country Code = 04
OK

ATI2
.............. CHECK SUM = 886C
OK

ATI3
Hardware Version 4.0 (Flash EPROM AB)
OK

ATI4
Internal Test running ...

T&V
Data Port Profile 1:
access control   = off               outside line     =·················
S mode           = dial connection   LAPD             = disconnect idle·
data service     = unrestricted 64k  TEI              = #  automatic····

default number   = # dial. from DTE  dial-in number   =·················
DTE protocol     = AT command set    character mode   = asynchronous····
rate adapt.prot. = V.110/X.30        data rate        = 2.4kbit/s·······
connector        = 25-pole V.28      DTR/C mode       = 2:DTReady  108/2
DSR mode         = 2:ready for data  RTS/CTS mode     = 3: DTR -> CTS···
DCD/I mode       = 2:DTR/C -> DCD/I  dataguard        = off·············
stopbits         = 1                 databits/parity  = 7/even··········
echo             = off               ISDN info. outp. = causes··········

E0 Q0 V1 X2 &C1 &D2 &R1 &S1 $D0 $X2 $O0A

S00=001 S01=000 S02=043 S03=013 S04=010 S05=008
S12=050 S14=0AH S21=74H S22=20H S23=00H S27=00H
OK

Data Port 1:····
no connection···
OK
</pre>