Project

General

Profile

OsmoBSCNAT » History » Revision 4

Revision 3 (Anonymous, 02/19/2016 10:48 PM) → Revision 4/17 (Anonymous, 02/19/2016 10:48 PM)

== BSC NAT/MUX == 

 === Introduction === 
 The OpenBSC NAT is masquerading multiple BSCs behind one. It listens for incoming BSCs on 
 port 5000 and connects to a specified MSC. It will forward Paging Requests and MGCP messgaes 
 to the right BSC (if it is connected). Each incoming SCCP connection gets patched with a different 
 Source Reference to avoid any collision between the different BSCs. 

 To the network the NAT looks like a real BSC, to the BSC the NAT looks like almost a real MSC. One 
 difference is that MGCP messages are not send via UDP but inside the IPA protocol to avoid 
 any issues with firewalls and such. 

 === Design === 
 ==== USSD Bypass ==== 
 We want to implement certain USSD messages ourselves, the MSC does not provide an extension 
 API so it must be done inside the NAT. On ther other hand we do not want to have complicated code 
 inside the NAT, the development of new features should not require a restart of the NAT. This means 
 we will have a simple bypass that detects USSD messages that we want to handle and then forwards 
 them to an external process. To begin with we will have a static decision making, which will be turned 
 into more dynamic pattern matching. 


 ===== Implementation in the NAT ===== 
 The difficulty is the management of the SCCP Connection. In case of a USSD operation as part of a 
 SMS or as a voice call, we should hope that sending the response arrives before the MSC is sending 
 the connection release. If the Connection is created with the intention of USSD we will have to take 
 over the connection and close it on the MSC side. It might show that this approach is tricky and we 
 might need better handling on the connection close. 

 * Keep track of the IMSI of every SCCP Connection. The increase in storage size is acceptable right 
 now. We have not started to tune anything in the NAT anyway. (done) 
 * Keep track of the Connection Type, identify SS requests in the CM Service Request (done) 
 * Listen on a port for incoming USSD Bypass connections. We will use the IPA protocol, with one 
    extra stream identifier for control messages. 
 * Identify USSD request to be forwarded to the MSC, send the IMSI and SCCP references to the 
   bridge so it can start doing its job. 

Add picture from clipboard (Maximum size: 48.8 MB)