Actions
Serial Console of the HSL Femto¶
There is a 3-pin header on the digital board of the HSL Femto.
It contains a RS-232 serial console of the TI DaVinci ARM core running at 115,200 bps
The pinout is as follows:- Pin 1: TxD output of Femto
- Pin 2: RxD input of Femto
- Pin 3: Ground
NOTE: There is a RS232 level shifter on board running the console at real RS232 voltage levels, so don't expect the typical 3.3V CMOS level.
Console commands¶
help Monitor Commands: lt - list tasks ct - clear multitask profile timers mr - read memory: mr [[AddressSpace]] MemoryLocation [[BytesToRead]] mw - write memory: mw [[AddressSpace]] MemoryLocation [[ValueToWrite]] crt - crt AS [[TaskName]] EntryPoint [StackSize] [Priority] [Weight] rt - Run a task: rt [[AddressSpace]] TaskName ht - Halt a running task: ht [[AddressSpace]] TaskName kt - Terminate a task: kt [[AddressSpace]] TaskName is - Enable / disable INDRT over serial: is [on | off] clt - close task: clt [[AddressSpace]] Taskname lA - list Address Spaces: lA lo - list Objects: lo [{+-}{aAcCilmstu}] [AddressSpace] la - list Tasks/Activities: la [AddressSpace] lc - list Connections: lc [AddressSpace] sm - Inject message: sm <AddressSpace> <Object index> "<message>" lm - list loaded images rset - reboots board (not always supported) bl - get or set board location (not always meaningful) map - display BSP memory table ti - task info: ti <TaskID> oi - kernel object info: oi <object index> <DomainID> nc [d<dev>] [[e [[EthernetAddress]]] | [i IPAddress] | [g Default Gateway] | [n Netmask] | [m Namesrvr] | [h Hostname] | [p<ON|OFF> (DHCP ON|OFF)] | [b<0|1> (TFTP Boot OFF|ON)] | [l Boot-Delay-seconds] | [t TFTP-Server-IPAddress] | [f filename-to-boot] | [r INDRT-Interface] [v SNTP-Server-IPAddress] | [z HH:MM Timezone Offset] | [o SNTP Polling Interval (s)] [s Save to non-volatile memory]] - network configuration
Updated by laforge about 8 years ago · 2 revisions