SignalScopePage » History » Version 1
max, 04/22/2017 04:04 PM
| 1 | 1 | max | = Signal Scope = |
|---|---|---|---|
| 2 | |||
| 3 | == Installation == |
||
| 4 | |||
| 5 | Before running the scope app, check that the following packages are also installed: |
||
| 6 | * GNU Radio |
||
| 7 | * The op25 blocks |
||
| 8 | * Frank's gr-fsk4 block |
||
| 9 | * The op25 repeater block |
||
| 10 | |||
| 11 | Other than these pre-requisites, no special setup or installation is needed. |
||
| 12 | |||
| 13 | == Running with the disc-tap option == |
||
| 14 | |||
| 15 | The signal scope does not require the USRP. If you have a discriminator-tapped receiver, use the "-a" option: |
