Project

General

Profile

Actions

E1-tap » History » Revision 5

« Previous | Revision 5/6 (diff) | Next »
laforge, 01/06/2020 04:15 PM


E1/T1 Tap

The Osmocom E1/T1 tap adapter allows you to tap into the communication of an E1/T1 line.

This is useful for tracing/analyzing communications on any type of E1 based interface, such as A-bis, A and core network interfaces in GSM networks, as well as classic ISDN networks.

Two RJ-45 ports are used for passing through your existing E1 line. Using a switch (SW1), the pass-through can be configured in straight or cross-over mode.

Two additional RJ-45 sockets are provided for tapping into either of the two pairs (Rx/Tx) of the E1 line.

An additional switch (SW2) can be used to select between high and low impedance tapping.

All ports are configured in Digium-compatible pin-out, i,e, pairs 1+2 / 4+5

PCB Photograph

Schematics

Schematics

Availability

The E1/T1 tap adapter is available for purchase from http://shop.sysmocom.de/products/e1-t1-tap-adapter

Files (4)
e1_tap_brd.pdf View e1_tap_brd.pdf 21.9 KB Component Placement laforge, 05/07/2017 04:46 PM
e1_tap.pdf View e1_tap.pdf 17.7 KB Schematics laforge, 05/07/2017 04:46 PM
e1-tap.jpg View e1-tap.jpg 154 KB laforge, 05/09/2017 05:09 AM
e1-tap-sch.png View e1-tap-sch.png 92.4 KB Schematics laforge, 05/09/2017 05:11 AM

Updated by laforge about 4 years ago · 5 revisions

Add picture from clipboard (Maximum size: 48.8 MB)