Project

General

Profile

Activity

From 01/22/2016 to 02/20/2016

02/20/2016

08:23 PM Feature #1473 (Rejected): verify if 80Mhz rate between ADC and FPGA works
laforge
08:23 PM Feature #1472 (Rejected): connect ADSCK to a DQS capable FPGA pin
laforge
08:23 PM Feature #1471 (Rejected): implement and test FPGA flashing via sam3u
laforge
08:23 PM Feature #1470 (Rejected): implement DFU bootloader in first 16k of flash
laforge
08:23 PM Feature #1469 (Rejected): make sure sam3u chip id is present in Usb Serial Number
laforge
08:23 PM Feature #1468 (Rejected): try to fit 2.5mm audio jack footprint (UART) on back side
laforge
08:23 PM Feature #1467 (Rejected): place "sysmocom" name into copper layer (back side)
laforge
08:23 PM Feature #1466 (Rejected): add footprint of 2x5pin 1.27mm pitch SWD connector
laforge

02/19/2016

10:50 PM Feature #1473 (Rejected): verify if 80Mhz rate between ADC and FPGA works
we might need a series resistor... laforge
10:50 PM Feature #1472 (Rejected): connect ADSCK to a DQS capable FPGA pin
this might help in terms of timing/clocking inside the FPGA, according to Sylvain/tnt laforge
10:50 PM Feature #1471 (Rejected): implement and test FPGA flashing via sam3u
implement and test FPGA flashing via sam3u laforge
10:50 PM Feature #1470 (Rejected): implement DFU bootloader in first 16k of flash
implement DFU bootloader in first 16k of flash laforge
10:50 PM Feature #1469 (Rejected): make sure sam3u chip id is present in Usb Serial Number
Using the device-unique serial number in the [[UsbSerial]] string, udev rules can assign persistent names. laforge
10:50 PM Feature #1468 (Rejected): try to fit 2.5mm audio jack footprint (UART) on back side
try to fit 2.5mm audio jack footprint (UART) on back side laforge
10:50 PM Feature #1467 (Rejected): place "sysmocom" name into copper layer (back side)
For WEEE reasons, if sysmocom sells the product, the brand name "sysmocom" has to be present on the device in a way t... laforge
10:50 PM Feature #1466 (Rejected): add footprint of 2x5pin 1.27mm pitch SWD connector
Cortex-M3 has this new SWD (single wire debug), which we should at least have on test pads. If there's space on the ... laforge
 

Also available in: Atom

Add picture from clipboard (Maximum size: 48.8 MB)