OsmocomBB » Nuttx-bb

NuttX compilation was done using CodeSourcery arm-2010.09-51-arm-none-eabi.bin, other toolchain could fail.

NuttX can be configured differently depending on what we want.
The possible configs are:

• compal_e88/nsh_highram : for the gta02 using the osmocon for the romloader
• compal_e99/nsh_highram : for the c155 using osmocon + loader.compalram.bin as a loader
• compal_e99/nsh_compalram : for the c155 using osmocon to load it

nsh is the nuttx shell(nuttx can also run standalone apps without a shell).

standalone nuttx¶

if you want a standalone nuttx(without linking to osmocombb for the drivers) do the following:
configure nuttx:

$ cd nuttx/tools
$ ./configure.sh compal_e99/nsh_highram

Compile NuttX:

$ cd nuttx
$ make

Load nuttx.bin into Motorola C155, because nuttx.bin is bigger than 64k, you should load chainload.compalram.bin together, use this command:

./osmocom-bb/src/host/osmocon/osmocon -p /dev/ttyUSB0 -m c155 /osmocom-bb/src/target/firmware/board/compal_e99/chainload.compalram.bin -c nuttx.bin

After loading you will receive this message:

Checksum on phone side matches, let's branch to your code
Branching to 0x00820000
Received branch ack, your code is running now!

Then press Ctrl+C and use a serial terminal of your preference, i.e:

Picocom:

picocom -b 115200 /dev/ttyUSB0

Minicom:

$ minicom -s

            +-----[configuration]------+                                     
            | Filenames and paths      |                                     
            | File transfer protocols  |                                     
            | Serial port setup        | <<-- Choose this option                                     
            | Modem and dialing        |                                     
            | Screen and keyboard      |
            | Save setup as dfl        |
            | Save setup as..          |
            | Exit                     |
            | Exit from Minicom        |
            +--------------------------+

Then:

    +-----------------------------------------------------------------------+
    | A -    Serial Device      : /dev/ttyUSB0                              |
    | B - Lockfile Location     : /var/lock                                 |
    | C -   Callin Program      :                                           |
    | D -  Callout Program      :                                           |
    | E -    Bps/Par/Bits       : 115200 8N1                                |
    | F - Hardware Flow Control : No                                        |
    | G - Software Flow Control : No                                        |
    |                                                                       |
    |    Change which setting?                                              |
    +-----------------------------------------------------------------------+