Project

General

Profile

Compile-without-sercomm » History » Version 11

« Previous - Version 11/12 (diff) - Next » - Current version
gnutoo, 02/19/2016 10:49 PM
we don't use sercomm anymore for serial by default....


NuttX compilation was done using CodeSourcery arm-2010.09-51-arm-none-eabi.bin, other toolchain could fail.

NuttX can be configured differently depending on what we want.
The possible configs are: * compal_e88/nsh_highram : for the gta02 using the osmocon for the romloader * compal_e99/nsh_highram : for the c155 using osmocon + loader.compalram.bin as a loader * compal_e99/nsh_compalram : for the c155 using osmocon to load it

nsh is the nuttx shell(nuttx can also run standalone apps without a shell).

standalone nuttx
if you want a standalone nuttx(without linking to osmocombb for the drivers) do the following:
configure nuttx: {{{
$ cd nuttx/tools
$ ./configure.sh compal_e99/nsh_highram
}}}

Compile NuttX: {{{
$ cd nuttx
$ make
}}}

Load nuttx.bin into Motorola C155, because nuttx.bin is bigger than 64k, you should load chainload.compalram.bin together, use this command: {{{
./osmocom-bb/src/host/osmocon/osmocon -p /dev/ttyUSB0 -m c155 /osmocom-bb/src/target/firmware/board/compal_e99/chainload.compalram.bin -c nuttx.bin
}}}

After loading you will receive this message: {{{
Checksum on phone side matches, let's branch to your code
Branching to 0x00820000
Received branch ack, your code is running now!
}}}

Then press Ctrl+C and use a serial terminal of your preference, i.e:

Picocom: {{{
picocom -b 115200 /dev/ttyUSB0
}}}

Minicom: {{{
$ minicom -s
}}}

{{{

---[configuration]------                                     
            | Filenames and paths      |                                     
            | File transfer protocols  |                                     
            | Serial port setup        | <<-- Choose this option                                     
            | Modem and dialing        |                                     
            | Screen and keyboard      |
            | Save setup as dfl        |
            | Save setup as..          |
            | Exit                     |
            | Exit from Minicom        |
------------------------
}}}

Then:

{{{
--------------------------------------------------------------------- | A - Serial Device : /dev/ttyUSB0 | | B - Lockfile Location : /var/lock | | C - Callin Program : | | D - Callout Program : | | E - Bps/Par/Bits : 115200 8N1 | | F - Hardware Flow Control : No | | G - Software Flow Control : No | | | | Change which setting? |
---------------------------------------------------------------------
}}}

Add picture from clipboard (Maximum size: 48.8 MB)