Serial Cable » History » Version 8

« Previous - Version 8/27 (diff) - Next » - Current version
vogelchr, 02/19/2016 10:48 PM
Added non-standard baudrates remark.

The Calypso phones typically all have a serial port @ 3.3V levels on the 2.5mm earphone jack.

Those cables are sometimes called ''T191 unlock cable''.

You can either buy ready-made cables, e.g. at: * USB variant * [] * [] * RS232 variant, you still need a separate standard USB/RS232 cable * [] * []

Or you can build it yourself (detailed instructions can be found on the net, search for "t191 unlock cable" or the like).

  • TxD is at the tip of the plug (PC to Device)
  • RxD is at the middle contact (Device to PC)
  • GND is the outer contact
Hints and Warnings * If you don't use a 3.3V (low voltage TTL, LVCMOS) serial port you can fry your phone! (internally, it connects to the IO-pins of the baseband processor which run at 2.8V). '''Don't connect directly to your PCs serial port (running at +/- 12V!).''' * If your development system is virtualized (runs inside VMware, Virtualbox, Parallels...) the connections can be unreliable (the loader protocol is timing critical). * Your safest bet is a USB cable with a FTDI- or Prolific chip (FTx232, PL2303) configured for operation at 3.3V connected to a machine running Linux natively. * If you want to communicate with the Calypso at baudrates higher than 115200 bps, you'll have to resort to non-standard baudrates. These are also supported best using a FTDI based USB adapter cable.
Add picture from clipboard (Maximum size: 48.8 MB)