Project

General

Profile

Actions

Background

The OsmocomBB source code comes with several applications for various purposes.
Those applications can be devided into two separate classes, applications:
  • running on the baseband chip of the phone
  • running on a PC, communicating with the baseband firmware over serial
Applications running on the PC can further be partitioned into:
  • Firmware management software (loading, flashing, ...)
  • GSM Layer 2/3 applications

The following will provide you a rough overview of the most commonly used software pieces.

Baseband firmware

Binary location: src/target/firmware/board/*/*.bin
Source locations: src/target/firmware/, particularly apps and layer1

layer1

layer1bin is a simple GSM layer 1 proxy, communicating over the L1A_L23_Interface.

This allows you to run a full-blown GSM implementation on your host machine, communicating through the phones radio interface.

loader

loaderbin is our flash loader, dumper and second stage bootloader

l1test (deprecated)

Layer 1 development application.

This application does what layer1 does, but automatically tunes to the strongest ARFCN it can find.

It can be used for stand-alone-testing of the phones radio.

compal_dsp_dump

Application for dumping the contents of the DSP in the Calypso chip.

compal_dumper (deprecated)

The old Compal device dumper. Use compal_dsp_dump instead.

hello_world

The initial obligatory "Hello, world!" application.

Currently, this does more than say hello. Intended as a template for new applications.

menu

Boot menu application to select and load apps that are stored in flash memory. See flashing_new.

rssi

The Rssibin can be used to monitor the received signal indication (RSSI) of ARFCNs or the entire spectrum.

EMI

The EMI (electro magnetic interference) simulator application can be used to generate RF interference caused by GSM networks an mobile station. See emi-firmware.

Firmware management software

Location (source and binary): src/host/osmocon

osmocon

osmocon is a console tool for interfacing our baseband firmware on the phone with applications on the host PC.

It is responsible for downloading a baseband firmware or bootloader into the phone and relay communication between Layer 3 applications and baseband firmwares over serial.

osmoload

osmoload is used to write, dump and examine flash memory of supported phones.

You will need this program for example if you intent flashing an application to the phone (the software is usually loaded into RAM).

calypso_pll

The calypso_pll tool can be used to calculate Calypso DPLL multiplier+divider.

rita_pll

The rita_pll tool can be used to calculate the Rita PLL multiplier/divider.

Files (0)

Updated by laforge about 2 years ago · 17 revisions

Add picture from clipboard (Maximum size: 48.8 MB)