Actions
Feature #4050
closedfinal osmo-clock-gen v2 changes
Start date:
06/06/2019
Due date:
% Done:
100%
Spec Reference:
Checklist
- clearance on short edges for slot-in mounting in extruded aluminium enclosures or "Baugruppentraeger"
- MTA-100 at "east" edge of PCB for daisy-chained power cabling
- TC-2050 instead of TC-2030 for "standard" JTAG/SWD like other boards
- remove "A" and "D" label on east and west side of jumper block
Updated by mschramm almost 5 years ago
- Checklist item clearance on short edges for slot-in mounting in extruded aluminium enclosures or "Baugruppentraeger" set to Done
- Checklist item TC-2050 instead of TC-2030 for "standard" JTAG/SWD like other boards set to Done
- Checklist item remove "A" and "D" label on east and west side of jumper block set to Done
Updated by mschramm almost 5 years ago
I did not yet find proper space and clearance for an MTA100 header, as the area is huge and bulky a possible 180° shrouded UEXT header would occupy.
Also the clearance area on the short edged could be even more generous (2mm is utmost minimum needed, 3mm would be better).
Updated by mschramm almost 5 years ago
- Checklist item MTA-100 at "east" edge of PCB for daisy-chained power cabling set to Done
- Status changed from In Progress to Resolved
- % Done changed from 70 to 100
finished compacting design and placing MTA100 header with 016e05e.
Actions