Project

General

Profile

Bug #3436

qmod: 1: WWAN LED activity not monitored

Added by tsaitgaist 3 months ago. Updated about 2 months ago.

Status:
Resolved
Priority:
Normal
Assignee:
Category:
firmware
Target version:
-
Start date:
07/31/2018
Due date:
% Done:

100%


Description

When the modem is reset (i.e. using the '1' or '2' commands over serial) the WWAN LED (yellow) of the corresponding modem on the qmod board should switch off.
This should be monitored by the SAM3S and any change should be displayed over serial:
"-I- 0: WWAN LED 0" when LED for modem 1 (ST12 port 0) switched off
"-I- 0: WWAN LED 1" when LED for modem 1 (ST12 port 0) switched on

This does not work for modem 2 though (ST12 port 1)

History

#1 Updated by tsaitgaist 3 months ago

  • Assignee changed from tsaitgaist to mschramm
  • % Done changed from 0 to 10

The LED status for WWAN1 is monitored my QMOD board (using ST12 and modem 1 and 2):
I 0: WWAN LED 1
I 1: WWAN LED 1
2Resetting Modem 2 (of this SAM3)
I 1: Asserting modem reset
I 1: De-asserting modem reset
I 1: CLK deactivated
I 1: VCC deactivated
I 1: WWAN LED 0

I didn't change the code.
Lets check together tomorrow and compare boards.

#2 Updated by laforge 2 months ago

  • Category set to firmware

#3 Updated by mschramm about 2 months ago

  • Status changed from New to Resolved
  • % Done changed from 10 to 100

Thanks - with current master this error has not been seen again.

Also available in: Atom PDF

Add picture from clipboard (Maximum size: 48.8 MB)