Project

General

Profile

Actions

Bug #1431

closed

use PA16 for UDP_PUP as required by SAM-BA

Added by laforge about 8 years ago. Updated about 8 years ago.

Status:
Closed
Priority:
High
Assignee:
Category:
SIMtrace hardware
Target version:
-
Start date:
Due date:
% Done:

0%

Spec Reference:

Description

The AT91SAM7 manual explicitly indicates in "21.6 Hardware and Software Constraints" that PA16 should be used for the USB pull-up function.

Theh PA30 that we're using is not working, i.e. it remains high after reset, pulling UDP_PUP low, disabling the pull-up resistor.

Actions #1

Updated by tsaitgaist almost 13 years ago

  • Resolution set to fixed

I wasn't aware of this constraint.
Now fixed in KiCAD (rerouting has also been done). gerber will be rendered with v1.0.

Actions #2

Updated by laforge about 8 years ago

  • Project changed from OsmocomBB to SIMtrace
  • Category changed from 244 to SIMtrace hardware
Actions

Also available in: Atom PDF

Add picture from clipboard (Maximum size: 48.8 MB)